Ats Handheld Inductive Loop Tester HILT 9000 Manual de usuario descargar pdf (Pagina 6)

HILT 9000 - Inductive Loop Tester

Function Controls

Power

Press the POWER push-button to turn the tester on and off. The

tester performs an initial self-test to verify that the internal

circuit is working. After the self-test is complete, the tester shows

the current battery level and the message: Ready: Select

Function. If the battery is low, a message Replace Battery will

be displayed.

Press and hold the POWER push-button during power-up to

display the serial number of the unit and the version of the

firmware as show in Figure 2. Release

the push-button to return to normal

operation.

The unit can be turned off at any time

by pressing the POWER button. The

tester shuts off automatically after 30

seconds of non-use.

Loop

ATTENTION

• Disconnect the detector from the loop before running

this test.

• DO NOT switch to a different test while the measure-

ments are being generated for the current test. Only

after the results of the current test are displayed can

a different test be performed.

Connect the test leads to the loop. Press the LOOP push-button

to begin the test. After the measurement is complete, the tester

displays the results as shown in Figure 3 on the next page. Note

that the frequency at which L and Q were measured is also

displayed.

HILT-9000 #1234

Self-test v.1.0

Figure 2

1 2 3 4 5 6 7 8 9 10 11 ... 16 17

Sin comentarios

Ats Handheld Inductive Loop Tester HILT 9000 Manual de usuario Pagina 6